Install the new Mazda Protege tail lens and bolt / screw in place. Remove the old Mazda Protege taillens and store in a way that the lens will not be scratched.For this reason, it is best to lightly hold the lights in place with your free hand as you unbolt or unscrew them. Be aware that the old Mazda Protege tail lights might fall immediately once the tension of the bolts is removed. Unscrew the Mazda Protege taillamps from the front or use a socket wrench to undo the Protege tail lamps from the back.Please note that if your Mazda Protege tail lamps have a harness that can be separated via a main harness that leaves part of the harness with the bulbs inside the Protege tail lights, you will still need both parts of the harness since the aftermarket Mazda Protege tail lights are designed to either re-use the stock bulbs (altezzas) or to connect directly into the bulb harnesses (LED taillights). If they are cold, you could also store them in a ziplock type of bag. Once the bulb is removed, place them in their original container (if available). For bulbs with round bases, you usually just push them in a bit, and then turn a quarter turn to release them. For bulbs with flat rectangle harnesses, you just pull the bulb firmly outward. Without touching the glass, uninstall the stock brake, signal and reverse bulbs (as applicable).This step is particularly important because tail lens, unlike headlights, often require a little force to come loose, leaving many people to inadvertently scratch their Mazda Protege in the process. If uninstalling your Mazda Protege rear bumper is required, make sure you have a safe surface to place the Protege bumper on and that the working surface below the vehicle is also safe in the event the bumper falls down. Apply painters tape on your Mazda Protege around the edges of your Protege's taillights to prevent any scratches that might occur while removing and installing taillamps. ![]() In these cases failure to disconnect the battery before attempting installation may lead to blown taillamp fuses or other damage. Please note that some vehicles (such as newer GMs) have extremely sensitive electrical systems. Also, be aware that you will probably have to reset your clocks, etc. If your stereo requires a key in order to reboot, please be sure you have it before disconnecting the battery.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |